Переглядів 2,700
DIY - Making a Cordless Drill Stand from a 795 Dc Motor Using a PVC Cover
segments
00:00 - Opening
00:49 - Parts
01:49 - Make Motor Cover
05:22 - Making sliding rails
07:27 - Installing the sliding rail mount
09:13 - Installing Motor cover on the stand
10:08 - Handle parts
10:35 - Making a handle
11:28 - Installing the Battery holder
12:05 - Installing the Switch
14:02 - Switch test (Reciprocating rotation and speed control)
14:46 - Wood Drill Test
16:00 - Closing
Parts:
- 795 DC Motor
- 795 Motor Bracket
- 20 Volt Cordless Battery
- Cordless Battery Drill Switch (7-36 Volt)
- Cordless Battery Socket
- PVC Sheets
- Timing pulley 16T B5 W15
- Timing pulley 48T B8 W15
- Timing Belt 110T W15
- 8mm Axle Rod
- KFL08 Bearing Bracket
- B12 Drill Chuck
- Connecting Shaft Rod adapter B12 Chuck
- V bearing 624ZZ
- Bearings 635Z
- Spring length 8cm, wire thickness 1.2mm OD 8mm
- Aluminum Strip 40cm x 3cm
- M4 nuts, M4 washers, M4 bolts, screws
Visit the Creatividea Channel
See other videos here:
/ @creatividea
Don't forget to LIKE, SUBSCRIBE, and provide suggestions and comments
Thank You