Hi everyone . We are going to manufacture a 4X2 buggy. It needs a differential with a locking system . So we hope to modify this fiat car differential and make it.
КОМЕНТАРІ: 22
@peters992928 днів тому
Hammers plate so it drops and hits lathe ways, well done
@modification_king_officialМісяць тому
You are great great engineer🙏🙏🙏🙏🙏🙏🙏🙏🙏🙏🙏🙏
@tinkernaut8736Місяць тому
Great fabrication!
@guilhermefranca3099Місяць тому
Fantastic!
@tOxIc_TrEaSuRe12 днів тому
what keeps the shafts from coming out ?
@barnes2951013 днів тому
👍🏻👍🏻
@mili9518Місяць тому
🎉
@wayne25197510 днів тому
What is the sprockets for?
@makeandride8 днів тому
for differential locking system
@harrywp578523 дні тому
No need to do this. Just use front wheel drive box. Bonus of od in 5th! Includes a diff as well. Sprockts onto halfshafts instead of cv. No brainer. Sv.
@user-th6gv9jh6z21 день тому
Think about it, front diff used in the rear,,,, what direction does it turn
@paulfrost895221 день тому
@@user-th6gv9jh6zyou could flip the diff 180 degrees sideways then left becomes right and reverse becomes forward!
@user-th6gv9jh6z21 день тому
Oil will be the problem if you flip a diff, overfill to correct this and you will blow seals
@paulfrost895220 днів тому
@@user-th6gv9jh6z Simple fix fit a pressure release valve! Improvise, Adapt, Overcome.
@ThatOneGuyWithTheEyeМісяць тому
Throw the bearing in bone dry well done
@jamesmarsh183124 дні тому
The bearing is a seal-less bearing that is lubricated with differential oil like all differentials, the seal and axle is what needs to be lubricated before they are installed but that was more than likely done once finished and installed and what was shown was for quick video shooting purposes.
@cato9tales14111 днів тому
One I, 1/2 brain....8^)
@klaus-dieternubaum340717 днів тому
Möchte ich auch sagen: völliger Unsinn, was soll man damit?