Do you have any tips on getting the belt back on I just replaced my alternator and just took the belt off by pulling down and off but now I can’t get it back on would appreciate any tips :D
@dizzybuiltit91388 місяців тому
If it's to tight then watch how I explain it at the 5:45 mark in the video , if you don't remember the pattern it was on then you can probably find the diagram on Google
@OnJaee8 місяців тому
@@dizzybuiltit9138 I have the tensioner as far back as I can get it and the belt still won’t get on and it’s the factory belt idk what to do
@dizzybuiltit91388 місяців тому
Maybe it's the way you are routing the belt. If it's the right size it should go right on
@OnJaee8 місяців тому
I have it right idk if when I pulled it off it messed up a pulley maybe
@OnJaee8 місяців тому
@@dizzybuiltit9138 I know this is a lot to ask but do you have a discord so I can video call you and show you I would greatly appreciate you man if not it’s cool
@LP-lu1hy9 місяців тому
Did the shake stop after you changed those 2 motor mounts
@dizzybuiltit91389 місяців тому
The little vibration stopped. I just recently changed my 2 shock mounts also, both of them had cracks in the rubber on top. I have some shaking coming from my wheel now, I plan on changing my wheel bearings next
@joel_19466 місяців тому
@@dizzybuiltit9138how much km or miles?? I have vibrations too i replaced right driveshaft and they reduced but still little vibrations 😬😬
@dizzybuiltit91386 місяців тому
@joel_1946 I still have some vibration man. I have almost 100k now but it's been going on for a while and it just got worse over time. Especially when I hit about 70mph & up. I think I figured out the issue, im thinking it's the rear engine mount. I have it but I didn't change it yet. When I do I'll put up another video to keep u guys updated
@joel_19466 місяців тому
@@dizzybuiltit9138 i have to do some test today if i still feel the vibrations i will change the 4 engine mounts. Thx for the video 😉 i have 66k kms.
@dizzybuiltit91386 місяців тому
@joel_1946 ok let me know please. Thank you for watching
@carlosvpallares1407Місяць тому
Whats the name of the tool set you bought Amazon’s thnks
@dizzybuiltit9138Місяць тому
Torx & external socket set
@BIGPAUL310Рік тому
Did you change the grill CLA ?
@dizzybuiltit9138Рік тому
Yes, I got the GT grill from ebay. I think it was about 80$
@ricardoflores5711Рік тому
@@dizzybuiltit9138 did you do a video on how to replace the grill for cla ?!?
@dizzybuiltit9138Рік тому
@ricardoflores5711 I might have one in my phone. If I do, I'll upload it
@ricardoflores571110 місяців тому
How many motor mounts are on the cla 250?
@dizzybuiltit913810 місяців тому
3 motor & 1 transmission mount
@ricardoflores571110 місяців тому
Did you replace the transmission mount or just the engine mounts
@dizzybuiltit913810 місяців тому
I didnt replace the tranny mount yet
@dizzybuiltit913810 місяців тому
I think it's fine though
@ricardoflores571110 місяців тому
Did you use Jack stands on both sides or just the passenger side for the tire?