In this video I present to you small but great sounding horn type speakers.
With a height of 250mm, a width of 100mm and a depth of 130mm.
To make it, I use 10 mm birch plywood, which has very good acoustic properties.
I use a laser engraver Atezr L2 36W to cut the individual elements to assemble the speakers.
Model lezer engraver: Atezr L2 36W
Link if you want to buy the product: shln.top/z7YD8yC8
The speakers I use are.
Broadband speaker, ONKYO SUPER SOUND X20 Impedance: 5 Ohm Power RMS: 7.5W.
High frequency. NAKAMICHI SP-T13 Impedance: 4 Ohm Power RMS: 10W.
Speakers with good sound were obtained