instablaster...

Yep you can. Just make sure they're around the same size as the locking hole.

The crankshaft sprocket can only be installed in one position! Fits only once. On the sprocket behind it there is a cam on the front side which must match a hole on the crankshaft pulley. In addition, there is a marking on the timing belt cover, this marking must be aligned with a notch on the edge of the crankshaft pulley. You can also find the instruction in the PIC.

En español

Hello Arts&Trust TDC 1st cyl. Determine by means of a screwdriver, remove the 1st cylinder spark plug and insert a screwdriver into the spark plug bore. Turn the engine until the screwdriver reaches the highest point. Now adjust all markings on the engine as described and pin them with the tool. Best regards, your Continental Aftermarket Team

Hello, I woulld really like to help you, can you please repeat the question? Best Regards Stefan

Hi, I think he is saying will the pistons bend or contact the valves if the belt breaks with the engine running?

Sehr gern. 😊

Please excuse. Could you please write your question in more detail? Otherwise, we can't help you with your question.

thank you :)