Learn how to install LED Lighting in any PC case using LED strips.
The process is very simple ant the tutorial is easy to follow.
F.A.Q.
// Which LEDs am I using?
// I had this cheap roll of LED strip laying around that I bought from a local hardware store. It's a single coloured 12 V led strip.
// Which LED Strips can be used?
// Any strip as long as it runs at 12 volts DC and requires only 2 power connections (12V and Ground).
//Can you use RGB LEDs?
//It Depends, if the strip has a controller at one end to control the current and only requires power no data signal, then you can use it. But if it has 4 contact points that need to be connected than this method won't be sufficient.
//Can you turn the Lights on and off?
//The LEDs turn on when you boot up your PC and turn off when you shut down.
If you wish to keep the LEDs off while the PC is on then you will have to physically unplug the wires from the Molex Connector.
//Do you need the Jumper wires?
//NO. My power supply's Molex power line came with the female header at the end which makes the jumper cables a perfect fit but if you don't have jumper cables or the female header at the end of the molex connection wire then you can simply connect normal wires to the molex connector.
//IF YOU HAVE ANY QUESTIONS, YOU CAN LEAVE THEM IN THE COMMENTS BELOW!
How to build this PC : • How To Build A PC [GTX...
MUSIC : Invisible - UKposts Music Library