You just solved a MAJOR problem I had. You have my deepest gratitude my friend!

Same here, I spent so many hours trying to solve the +ERR=1. You have my deepest gratitude my friend!

Found this channel yesterday, very useful content for an ece student.

Nice explanation sir..

Thanks for the video

Thank you so much sir...saved me from those err+1 !!

Thank you

Hello very nicely explained. After setting BAND to 867 MHz and when it is reconnected to serial monitor it shows value of band to be 915MHz. Is there any AT command for saving the changes?

👍👍👍

Hi Thanks for this video . I need your help with an issue I'm facing .When I connect the Reyax module with the FTDI module I can communicate with it through serial port of Arduino Ide .But when I try to comunicate with the module connected to a esp32 WIMOS LOLIN 32 ,I type AT on serial and no answer from the module .I already installed the drivers and don't work any way Regards

Can we do the same work with FPGA instead of microcontroller?

Sir how did you buy from reyax rylr896 lora module ? There is no buy options in the website .. I'm from Chennai

hi sir , how to configure lora module as many transmitters say 9+ AND one receiver ?

I could not understand how to make receiver to listen to only particular sender, I have two transmitter Lora Module transmits some data, consider these as T1 and T2, and one receiver Lora modules R1. Here receiver module R1 receives data from both transmitter T1 and T2, So how can we make R1 to receive data from only T1?

Sir Can we establish two way communication between lora modules over a long distance Can you please make a video tutorial for it