Appreciate your comment and support! Thanks.

Thank you, I appreciate your comment and it encourages me to do more work!

Así es… y también me encanta la intimidad que se crea con la materia. Gracias por haber mirado!

Thank you

Great idea. As soon as you said using a chisel it all made sense! Thanks for the tip.

no problem it looks lovely something so simple but elegant about walnut and dovetails just makes it look even better

In small work this is impossible. London pattern dovetails, for instance, only have a saw kerf at the narrow end of the sockets, and there is no room for anything other than a thin knife blade. The issue is never the marking. The issue is always getting the tail board correctly located, and keeping it there.

Thanks for taking the time!

Thanks! More to come :)

Thank you. It’s always encouraging to read comments 🙏

Thank you so much!

Dovetails are pretty 🥺

Appreciate your feedback!

Thanks for the support. I don’t think it was loose on the vice. But I must say I haven’t found the perfect method yet…!

Looking at 4.55 in the video and there's a definite gap

@@jclwyd Oh that's just because my vise is quite big and when I only tighten one side, it's doesn't "bite" in parallel, so the vise is off axis. It's still very tight but not fully "in contact"...