Power Your Projects With Batteries! (LiPo/Li-ion)

День тому

Adding batteries is often one of the more confusing parts of creating a portable electronics project. Learn how to to use LiPos in these portable projects without them exploding.
-- Links --
My Website: sinelab.net
Buy me a coffee: www.buymeacoffee.com/thesinelab
Bitcoin Address: bc1qwlfr2ml9km4r5vhpfh7f3m60k80whhcq3ysths
Ethereum Address: 0x7e8B8Ff8D6bD8DfB48b4A139694BB343f040Bb3f
--

КОМЕНТАРІ: 30

@cpk001 3 місяці тому

Thank you, your video answered a number of questions I had regarding charging lithium batteries.

@SineLab 3 місяці тому

I'm glad the video helped

@GiNodrog Місяць тому

Thanks for the informative video. I bought a gadget to charge the battery and was slightly alarmed when it indicated fully charged 3.7v cell to 4.2volts .

@salemabo8147 Рік тому

I thought i knew almost everything about the topic until I watched your video ❤

@SineLab Рік тому

I'm glad that you learned something from watching! :)

@narayanbandodker5482 Рік тому

The main problem with using a rechargeable battery is a circuit that can supply power even while charging (charge power separate from output power). TP4056 kind of works for it, but what we really need is a PMIC

@xzddakfdmiug5832 Рік тому

The hot plate that you used greatly improved the look of the circuit board, although it is fun to use a soldering iron.

@SineLab Рік тому

It makes SMD soldering much, much easier.

@YigalBZ 4 місяці тому

In case for a 5V controller supply: Is there a one module that does the charging and DC2DC to 5V? the modules with PCB are quite big.

@sanjaybatra6593 2 місяці тому

which mosfet you have used ?

@sanjaybatra6593 3 місяці тому

Sir, I am looking for a battery backup for my AVR microcontroller. I am using 5V 3A SMPS to run my microcontroller board. What I want is: When MAIN Power Supply goes OFF suddenly- due to power cut, then microcontroller switch to battery. Is there any Module available in market , Which Switch between "5V Battery" or "5V SMPS" depending of situation. Also battery should charge automatically. Please guide or make a video on this topic ......

@benjaminmolnar3881 Рік тому

I was literally looking into the same chips today. I have an application where I usually have my device plugged into USB C 5v for power, but I would like to be able to unplug the power and still use it with a battery. I found some boards that do exactly this and have a 5V boost converter to bring the 3.7V up to 5V. Unless I'm misinterpreting what I ordered on Amazon this chip solves all the problems.

@SineLab Рік тому

Yes, they should work, considering that they have the necessary protection features.

@mudstrand 7 днів тому

Can the TP4056 provide enough power for a ESP32 WROOM-32 board? Can I use 2 18650's in a holder with the TP4056?

@phillipkusinski6365 Місяць тому

Is it now possible to use the LIPO battery while charging?

@henriquealves4068 3 місяці тому

Hey there, thanks for the video! I'm kind of new to making electrical projects such as these, and I was wondering if the battery you use would be able to power a microcontroler such as an ESP32. I noticed the voltage works fine and could work even better if connected to a voltage regulator, but was wondering about the current. Does it supply enough amps for the ESP to work?

@SineLab 2 місяці тому

LiPo batteries can supply a lot of current. It is more than enough to power an ESP32.

@jumbo999614 Місяць тому

At 6:30 you connect Battery to TP4056 and then to LM2596 right? I'm connecting two 18650 batteries to LM2596 to supply 5v 3a to my GSM module. It's working fine but I want the circuit to shutdown once the batteries are low on power.

@SineLab Місяць тому

You can find battery protection ics. They will disconnect the battery from the circuit when it has been over discharged.

@zapo1034 Рік тому

could you please continue the am transmitter and receiver? and maybe move to fm transmission (because there are not many intermediate videos, only beginner with no explaination or hardcore theory)

@SineLab Рік тому

I'm still working on those, I did a battery video in the meantime :).

@Brian_Of_Melbourne 11 місяців тому

Are you sure that Li-Ion and LI-Po are the same? Maybe they aren't exactly the same! en.wikipedia.org/wiki/Lithium-ion_battery en.wikipedia.org/wiki/Lithium_polymer_battery and for good measure en.wikipedia.org/wiki/Lithium_iron_phosphate

@andymouse 5 місяців тому

"essentially the same thing" is correct and they are "essentially" but the 'Lifepo4' can catch people out.

@AlenHR 3 місяці тому

@@andymouse it is essential to understand that different batteries have different usable voltage ranges. This is critical for power delivery circuit. For instance, LiPo batteries can withstand voltages of about 3V without any damage, while LiIon batteries can go as low as 2.5V. Therefore, it is crucial to consider the specific voltage range of the battery you are using when designing a circuit. Remember, there is no "essentially the same" when it comes to designing circuits.

@andymouse 3 місяці тому

was pointing out the fact that a lipo and a lion can be used with the same chargers and they can, plus the fact that Life are a different kettle of fish and nobody mentioned the over discharge threshold at all besides it was 2 moths ago. and I don't need a lesson in design from a total stranger on youtube ! good day to you Sir.@@AlenHR

@landondavid5773 4 місяці тому

Why did you voice over your intro 🤪 I’m sure it was just fine. Don’t care so much. Just do you. You are incredibly smart and a wealth of knowledge. You are appreciated. Don’t care so much about perfect presentation. You will find that people may also appreciate you not cutting things out or including mistakes that were made because it makes you feel more human and more relatable.

@landondavid5773 4 місяці тому

EDIT: my computer was lagging and had the video misaligned with the audio. My apologies. However I still think the advice I provided is solid :p thank you for everything you do.

@SineLab 3 місяці тому

Thank you. It's good to hear that you appreciate the videos :)

@cutemera7255 2 місяці тому

let people do what they want lmao