RGB LED cube 4x4x4
Переглядів 2,116
Рік томуIn this video, I'll show you the build of a 4x4x4 RGB LED cube. An ATtiny85 microcontroller was used to actuate the RGB LED's. Shift-registers were used as a way to increase amount of IO's. Transistor-arrays were used for load switching.
Have fun watching!
@ShawankumarParida 2 місяці тому
Awesome video😊 I want to make a led(100+) strip with addressable led control using arduino or esp32!
@TimReuijl Рік тому
Great project and easily explained!
@Booruvcheek 7 місяців тому
I like the video, and the project, but it shows how much electronics you need to drive these RGB LEDs. And this is a smaller cube, a 4x4x4. This is why I have decided to go with individually addressable RGB LEDs (ws2812 or equivalent). All they need is 5 volts, and a single signal input wire, which just then goes out of the LED to the next one's input. You can then use a publicly available library, e.g. FastLed, to drive your LEDs.
@cmonMakerD 7 місяців тому
Yes, this would be a very good approach indeed. Simpler.
ZAXID.NET
Переглядів 544 тис.
Осторожно: Собчак
Переглядів 8 млн
SS Electronics
Переглядів 7 тис.