It’s hard to stop and It works better under load in most app.

Where..?

Where from ?

Microcosms

@@mooniedizzel6443 Thank you

Tanx...👻

No I have not tested the rpms yet. I have been using the turbine to test the out put of my boilers. I will show you a few setups in closer detail.

ukposts.info/have/v-deo/j2OVoaCofXqItmQ.html Here is the turbine on a little 3” P.m. research boiler. It’s not doing to bad to be such a small boiler.

It works better under load believe it or not. I could hook it up to a electric motor and see how many watts it can produce.

@@mooniedizzel6443 I would most certainly look forward to those result 👍

@@SomeGuy-tz8dz just for you I think I’ll see if I can put a airplane prop on it for a load test. I have a marine test tub for engines. If you look in my videos you will see it. I think the turbine would make a mess with it. 😅

Sorry it took me some time to set up a dynamo on the turbine. It maxed out the dynamo on 7:1 underdrive. @5300rpms 10VDV @ 10watts No load 12VDC Max current 2.4amp The turbine was not maxed out.

In real stem plants they reuse the steam up to 3 times. They heat the exhaust in a super heater. You reheat the exhaust by running in the boiler flue then reuse it in a turbines second stage. The Titanic reuse the exhaust from two triple expansion engines to run a turbine. The turbine range the center prop.

Thanks 👍🏽 sorry about the earlier reply. I was responding to another post. 🤪

Yes... Condensation recovery... That too will require more thought and work...

Rankine cycle, regenerative rankine cycle

Microcosm.

Sorry it took me some time to set up a dynamo on the turbine. It maxed out the dynamo on 7:1 underdrive. @5300rpms 10VDV @ 10watts No load 12VDC Max current 2.4amp

Don’t even try it. He tried to trash the fact the engine was from China.

I don’t ask you or him to come look at my videos. But here your are starting to bother me. Get all this started over a TOY. But you’re in your right mind, right?

eBay or microcosms.

It’s has a normal impeller.

www.microcosm-engine.com/live-steam-turbine-engine-multistage-reduction-group-jbb-p-142.html#.Y1aqcCUpAWM

My thanks...👻👻👻🤠😜

@@jamiewhale5317 ukposts.info_PO2TIgv_20?feature=share

No.

Steam

And if there would be a way to boild water with just a little form of energy and strong magnets the Aluminium still could take in a "green" place ;)

btw.. some guys know where "the circle closes" ;)

No sir.

Yea I have a small clip of it running a dynamo, hooked to a boost buck converter. I dropped the volts to 5.5 and use it to charge any usb device.

ukposts.info/have/v-deo/g3x9eIh7ba-nwJs.htmlsi=4U68DlufHgRZpIFM

How big and what psi would be needed for a 3500w generator

@@joshclark121987 around 45psi if the steam isn’t too wet. You will not have to open the valve on the boiler all the way. Depending on how dry the steam is the valve could be barely cracked open for full operation.

@@joshclark121987 10v 2.4 amps 10watts is all my dynamo will put out.