Step-by-step guide of how to configure the u-blox C101-D9S with ZED-F9
Переглядів 3,533
День тому0:00-0:50 introduction
0:50-1:33 pre-setup
1:33-2:38 how to connect the boards
2:38-4:15 configuration
4:15-6:09 configure NEO-D9S
6:09-8:31 configure ZED-F9P
8:31-10:08 debugging
10:08-10:31 ending
C101-D9S application board: www.u-blox.com/en/product/c10...
EVK-F9P: www.u-blox.com/en/product/evk...
PointPerfect: www.u-blox.com/en/product/poi...
Find answers, ask questions and connect with our community of u-blox users from around the world: portal.u-blox.com/s/
Check out our social media channels:
Facebook: / ublox
Twitter: ublox?lang=en
LinkedIn: / u-blox
Instagram: / ublox_
@susilo5667 Рік тому
Could you please provide tutorial how to integration neo d9c and f9p using usb ang u-center
@ublox Рік тому
To properly set up the system, please follow the rules up to 2:38, after which you can disregard all messages pertaining to SPARTN (such as SPARTN-USE_SOURCE and RXM-SPARTNKEY), as well as any discussions regarding Thingstream. At 4:51, ensure that CFG-MSGOUT-UBX-QZSSL6_UART2 is selected, and at 5:22, configure the UART baud rate and protocol. If you have any further inquiries, please contact the support portal, where someone can provide more specific guidance and assistance in Japanese, as these signals are only available in Japan.
@susilo5667 Рік тому
Actually we cannot use spartan, because outside of Japan
@ublox Рік тому
The original answer was meant for D9C for CLAS, which is available for Japan. If this is not sufficient, please ask in our support portal and our Japanese support will help you: portal.u-blox.com/s/
Жекич Дубровский
Переглядів 3 млн
Физика от Побединского
Переглядів 180 тис.
PRO Hi-Tech
Переглядів 88 тис.
Сэм Альтман рассказал о GPT-5 и будущем OpenAI | Роботы Tesla вкалывают на заводе | Робопчелы и Марс
PRO РОБОТОВ
Переглядів 54 тис.
KESHEE BATTERY
Переглядів 8 млн