In this restoration of the old rusty pipe wrench, I have inaugurated my new laser, in which I have applied a laser engraving on the pliers. The very old water pump pliers I had to hot bluing so that it is protected from rust in the future and the handles covered with liquid rubber. Furthermore, when restoring the old pliers, I had to drill, file, remove rust, sandblast, hot bronze and laser. I found this old hand tool in an old barn and had to have it for this restoration video.
▬ What did I do ?! ▬▬▬▬▬▬▬▬
The old water pump pliers was heavily rusted, so I sprayed with rust remover the moving part of the pliers, that was enough already fortunately to be able to open them again. After disassembly I had to remake the pivot bolt, since it could not be knocked out I had to drill it out. Afterwards I sandblasted all parts in the sandblasting cabin. To protect the pliers from rust in the future, I heated the components in the hardening furnace and cooled them in oil, this process is called hot burnishing. I covered the handles with liquid rubber to make the pliers feel better in your hand and to protect you from possible electric shocks. Finally, I laser engraved a laser engraving on the old water pump pliers with a laser machine.
▬ Good to know ▬▬▬▬▬▬▬▬
I used the following tools: Rust remover spray, pin punch, hammer, propane torch, starter, cordless screwdriver, drill, chisel, lathe, lathe chisel, pliers, milling cutter, sandpaper, sandblasting cabinet, corundum as abrasive, file, key file, hardening furnace, forging pliers, canola oil, rubber coating, screw, ratchet, laser machine.
▬ Do you want to support me? ▬▬▬▬▬▬▬▬
Would you like to become a channel member? Then you can do it here:
/ @forgottenshinerestora...
You like what you see and you want to help the channel to develop continuously? If you want to support me you can donate via Paypal:
www.paypal.com/donate?hosted_...
▬ Did you like it? ▬▬▬▬▬▬▬▬
Did you like the video? Then like, subscribe and please share it!
Many Thanks!