Filter goes on the return side after the coupler bar return side hose before going to the tank

Very good point. I've seen a gearbox wrecked with the right PTO but fitted with no shims, it broke the teeth off the drive gear.

jeffrey masurier you can’t drag a pit around with you to job sites.

Genius idea. I'll do the same when welding a Diesel tank that has fuel in it. Never thought to do it with a hydraulic tank though.

👍..

15mm !

On a 6 bolt

.018 - that one is gonna rattle a little.

It will tighten up more wen all the bolts get torqued down

@@harley2die4 Can't be true. She shows ambition.

Gday again mate

I use larger pieces of scrap cardboard, Yes large rocks chew thru and oil soaks. Sometimes only get one job out of a piece. Easier to slide on with no splinters is a big advantage.

ACatKrom I thought the exact thing when I saw the door. That’s pretty cool

Sounds like you got a master class in how to do it properly, you can thank Warren later.

Yea I do it by feel as well on my truck But if it fails I can only slap myself and don't tell anyone, never had a failure But how's that going to hold up when the customer what's to know why he's stuck on the side of the road If your doing it for other people you gotta be careful cause it's not just the driver chasing you down Bloke in the local town fitted a pto to a kenworth, he'd done it loads of times over 30yrs Part of that is remove 1 fuel tank cut it in half and convert one half to the hydraulic tank Driver was going cross country and the tank cracked Dropped 500lts of deisel on the road Yea big drama just replace the tank $2000 Exept he was in the middle of nowhere so its a 1000km drive out there, he had a freezer van on so the 20toones of cheese cake was destroyed by the time the truck got going And there's 500lts of deisel on a main highway By the time it was all said and done it cost him $50k for the freight loss environmental clean up and paying another mechanic to go out and replace the tank Insurance didn't cover a cent because he never got the tank tested and wasn't a qualified welder Nearly sent him broke in the end Had to sell his business Gotta follow the rules when someone else is paying the bills

You want a medal or something

@@gregshearer423 ,Yes thanks, a medal would be good

@@gregshearer423 He wants confirmation that his half assed approach is approved by the Warren massive.