I just put a handle in a old Warwood 5/8" punch on my channel. The handle was to be used for a Herbrand 32oz ballpeen. I customized a stubby handle for the Herbrand that turned out nice.

Thanks for the feedback!

We've had great luck melting down about 1lb of steel for wootz pucks! We haven't experimented with any other alloys or non-ferrous metals yet- but more testing is underway! Would love to hear about what kind of work you need this thing to accomplish for you. We'll do some testing and see what we can find out :)

Said he had that done here in Anderson too of all places

Thanks Greg. Miss u

The 15 kW is 2950 and the 25kW is 4495

This may seem like a hurdle, however the US solid will only grant you a heating unit and it's more than likely not a single phase 25kW unit. What you're getting for our higher pricing is an incredible heating unit that is still single phase power paired with an industrial chiller that refrigerates and cycles your water, giving you a 100% duty cycle on your machine. You're also getting a warranty and American customer support!

That cord can be a little pesky at times, but it's just another thing you've got to be cautious about when forging :) glad you liked the unit when you got to try it!

It sure is! Send an email over to [email protected] to schedule a demo in our school. Depending on your location, it might be easier to find us at a show near you!

😂

It likely is different than what you have on your set up! We’ve just recently started implementing these conical tip set screws for all of our die holding because of its hyper rigidity and better performance. It helps the dies self align in the press and eliminates any issues with slipping or even shearing that we’ve seen with our previous iteration. While the old set screws still work fine, this is just a step forward in our die holding development 😊

@@CoalIronWorks will they be available as an upgrade or not compatible? Thanks!

@@barrett5229yes! Just take out your current and replace with a fresh set! We don’t yet have them on the site but email [email protected] and Francis will get you hooked up

@@CoalIronWorksthanks! I have some on the way. Just to be clear these will work with older die sets? Or was the die redesigned as well

Hey there! I'm sorry to hear that you've had issues with your punch and stripper dies! If you'd like, please email [email protected] with what went wrong and they can help you get that resolved.