Did you watch the video!?

@@bmonden tes but he dont Wear mask

honestly i just strap an empty water bottle underneath normally dude! I see people using pool noodles too

@@georgeashcroft 10x i was thinking for the noodle

A naked vista will be easier to coat than a normal vista, that’s why I didn’t bother. My vista is still fine after being dunked I don’t know how many times. As for battery, just use one you don’t care about too much, it’ll get wet, but it’ll still work 👍

@@georgeashcroft cool, thanks!

Nah dude should be fine, either take off the heatsheidl if it gets in the way or just shove a load of worry free on top, havent seen a flight controller it cant cover yet 🙌🏻

Thinking might just need a water only drone?

I imagine it lasts basically forever if there’s no damage, goes a bit yellow after a year or so but still going strong. If you need to change parts you can solder right through it and put more on top, leaves your iron a bit messy though 👍 I only use this quad when I have to for flying over water, strap on a floaty too 👌

@@georgeashcroft appreciate you!

Thanks bro, I don’t actually use a transition pack at all, I just pick and choose free assets I like and I combine them myself. In this video I’m pretty sure all I used were “4K light leaks” and a few transitions I made inside premiere 🙌🙌 glad you liked it man

You don’t really, I just sealed the xt60 good and proper. I also just used a battery I kinda don’t care about… Having said that, the battery did dry off and I used it plenty more 👍

Hahaaa thanks man 😂 good ol “your dad”

🙌🏻🙌🏻🙌🏻👊🏼👊🏼🙏🏼

Thanks dude! Gotta be short these days people attention span is less than a fish 😅

@@georgeashcroft …btw, on Tuesdays Joshua Bardwell & Blunty have an FPVnews stream. I’ve sent them rhe link to your clip in the hope that it’s shown. I hope it gets seen. 👍

Thanks 💪🏻🙏🏼

Nope, just rocked up and flew. I talked to a few people there first to make sure they were ok with it. And to make sure there were no Basejumpers about to jump

It’s quite easily removable with a craft knife! It’s just like silicone 🙌🏻🙌🏻

Yeah looks cheap as. How is removing multiple coats of conformal coating?

@@JaydenLawson if you use alcohol and a silicone brush it comes off great. This stuff isn’t too bad if you apply it incredibly slowly with a needle tip syringe.

this build has a vista in it, so not analog. but yes! exactly the same wiring procedure

@@georgeashcroft ah my bad! sweet. I've got a DJI Avata but want to build my own quad!

@@georgeashcroft have you ever had any problems with loctite getting into the motors?

i always only travel with handluggage, i dont bring tools besides a grip and an "allenkey?" with me and props are no problem besides egypt :D

Ngl i made a boo boo. The project i was working on before this one was all shot in 50fps due to 50hz light flicker. I used the same export settings and rushed the upload on youtube. So i filmed it in 30/60fps and rendered in out in 50 by mistake🤦‍♂🤦‍♂ doh! I'll re export it and upload again at some point. Basically, short answer.... I fu**ed up and left it because i was feeling lazy hahaha

Thank you so much dude! Appreciate it!