Thanks for posting this. I was trying to find a video explaining how much gap to use when adjusting the motor. You are the 1st person I have seen really explain things. Your paper trick worked great.

i was wondering what was going on with my rear end almost dragging. thanks for the gear mesh trick with the paper. smooooth now

Best video about rc cars... Clear explanation 🙌🙌🙌

Instructions are pretty clear.. i suggest using less editing effects because it can be irritating sometimes but overall really informative video, cheers

Thank you so much for making video about rc drift

Thank you for this video. I've seen them all "for beginners". It helps me a lot.

Nicely done 👍As someone who's literally just now trying to learn about these things, this was a very well put together video. Thanks for the useful information 👍. Have a great day 😊

Expert tips here👍🏾

Fantastic video, Timmy!! 😁

Super content. This is definitely for a pro

Nice video. Maybe next time how to setup YD2 for Carpet ? :) Front width and rear widht

Awesome content! Keep it up! Ps: Music is a bit too loud

Very helpful

Awesome video👍🏻

Hi temmy great video Thankyou

Nice intro

Hello from BKK THAILAND lml/

Hi i have one mst 2.5 and he runs very slowly when give throtlle he stay in the same place or move slowly. You think tou can help me to do a setup for car? Thanks

regarding the Thread Lock Compound, as far as I know, it should never be used on the Plastic Parts because it can react badly with the Plastic causing the Plastic to eventually come brittle and crack maybe not all plastics are equal, or even Thread Locks but it's best to use them only where the screws are going to screw-In aluminum parts.

Is it okay that my abec-5 bearing rolls for 4 seconds then stops, does that time continues front axis movement in drift or i could just push throttle and it will continue rolling?

I want to ask, what is a good beginner RC drift car? There are a lot of bad ones and I can't seem to find one that is quite good. Please, someone help.

How to make rc car engine in home?

Where did you buy your car?

so can i ask so what does sanding the carbon fiber or lower body plates or whatever your talking about doing??? so two questions actually can you clarify what the sanding is for and areas to focus on sanding?? and second what does the sanding do?? 400 grit takes a lot of material off so i would love to know, if you were going for aero advantages 3000 grit or even finer combined with wet sanding would surely give the smoothest results!! so what parts should be sanded and also what does the sanding accomplish? or what is the point?? please clarify your videos are confusing me more than they are tips please help clarify I'm sure I am not the only person on youtube who truly doesnt understand the concept behind some of these tips here... your doing great at throwing out tips but not doing such a great job actually explaining what they do/ are used for/ will accomplish, just throwing out a tip need to spend a couple ten-twenty seconds explaining what benefit it will have on the vehicle!!!! your totally missing that piece of the puzzle with your tips videos!! please help me clarify and hope this helps you in the future to make more elicit and clearly stated and non-confusing videos, especially since they are help videos trying to provide tips to make rc drifting more fun and less work, i would love to know what these tips accomplish and totally thrown off by the sanding tip, i like soft edges just as much as the next perfectionist but WHAT DOES IT DO? MORE PRECISELY WHAT BENEFITS DOES THIS PROVIDE?? THANKS -P3T3R

Start watching from 1:00

nein