An interesting and accessible presentation; now 6 years old. Would be great to pull together a fresh overview of the current state of play for another presentation. If I knew enough to do that I wouldn't be watching this! Thanks.

What I like is they don't push Digi Mesh down people's throat, but still explain the rest fairly.

Great video, thanks for the explanation, really easy to understand.

Thanks for the simple and understandable presentation !!

Really clear and not cheesy. Thank you.

Very useful, thanks @robfaludi

One question is the speed of the internet on a mesh network would depend on the quality of the signal that the first node is receiving? and so on

is DigiMesh a protocol/product from your company?

Thanks for the education.

Hi! We are using Digi International solution (XBee-PRO® 900HP) to implement DigiMesh topoloy, like presented in this video.... we would like to check if xbee configuration (via x-ctu) is ok..... could you provide a tipical x-ctu configuration for a router node?!? Thanks!

Help! I need help setting up my network. I want to make sure i am getting the most out of my network and need help connecting these devices in the right order. Here is what i'm working with, -(ISP) Spectrum 400 mbps down/400 mbps up -Modem 4 ports with wifi (wifi can be turned on or off) -Router, Linksys EA9500 Max Stream -Router, Linksys Velop 3pk -Switch, TP Link 24 Gigabit Switch (TL-SG1024D) I have about 17 devices in my house that can be wired through ethernet and 5 that are wifi only. Thank You so much!!

Hi,is there any proper setting document that can i create mesh netwrok using multiple zigbee ,because created netwotk but it is not working properly,means it should be as co-ordinator ,router and end device setting seperatly in xctu

Which is better to use at sea??

which is better for communication with drone ?

hii, how to extend rang of xbee pro s2c 802.15.3

Why is it so damn hard to find GOOD help on Digimesh? I can't find a decent book, all I usually find are just using the serial monitor when what I want to do is use Arduino with Digimesh. Someone must know a good book???????

Good video but it is a little dated - needing refresh. For example WiSUN is now one of the largest 802.15.4 Mesh standards in active use worldwide with millions of nodes installed.

Yo it feels like LinkedIn up in this joint, yikes. This vid blows fragmented chunks starting at the hand-waving citation-needing nonsense at 1:48 "Lower latency [...] in some cases and added complexity in putting the network together" What cases? Compared with what? Mesh vs. non-mesh metrics likely aren't even fair to directly compare considering the mesh and distributed paradigm brings with it emergent properties which shift priorities (e.g. peer latency of 100ms is chill depending on your QoS requirements, let's say Mastodon toots or high-level IoT alert data). And we aren't "add[ing] complexity," *you* are, with your fancy-ass IPv6 dumpster fire overlay. Any version of IP at the network layer perpetuates your late-stage capitalist bullshit.