The best muffler is a power tool))

You mean like a glass packed muffler? Definitely helps with the high frequency noise. Baffled chambers like this are generally good for the low frequency noise. If you really know what you're doing, you go further with it by orienting the baffles in order to cause destructive interference within the baffled chambers (which is then called a resonator). But that is neither cheap nor easy to design.

Steel wool

The burning rubber fumes will be all around you. Good news is that it won't matter very shortly when the fire spreads to your clothing and you burn to death.

Not solid disk and it's not for a slug. It would have to be much larger.

0% improvement perfect !

It's not really for a weed eater brainiac... Think about it...

Showing off his unprofessional project skills poor boy we feel you 😂😂

Une vrai farce...!

Small 2t motors with pumper carbs like these don't really use jets that you can swap out, instead there's a low and high mixture screw. Super easy to tune idle and WOT

Fiberglass, a better alternative

The concept of suppressing noise made by hot gas is pretty universal

Indeed, but pay attention that the insulation material (I would use mineral wool) must be sufficiently dense so that the sound pressure waves are reduced in speed. I expect much larger noise reduction.

Tax stamp for what? It's not for a firearm. 😉

I think you missed the point...

Поделитесь мыслями,если без корысти.Мучаемся над данным вопросом.

@@user-oh9ve7xj8i берём трубу подходящего диаметра, насверливаем в ней отверстий диаметром 5-6 мм как можно больше ( чем меньше глушитель или резонатор, тем меньше диаметр отверстий) на всю длину насверленной трубы делаем корпус (глушителя или резонатора) и между корпусом и насверленной трубой забиваем базальтовый утеплитель или иной не горючий материал. Если по этому принципу делать глушитель, то получится прямоток немного громче чем заводской глушитель, но это будет Прямоток, если делать резонатор, то на выходе получится звук тише и ( мягче) чем заводской глушитель, из за того, что на пути отработавших газов нет препятствий, то и напирание этих газов меньше, соответственно двигателю легче крутиться...

i'm doing it for a dirtbike, but use steel wool and glassfiber, and at each step the total hole diameter should be bigger than the pipe you attach it to, the inside should be empty and the between should be with first steel wool then glassfibre also, use rubber gasket when mounting the exhaust to the frame, no rattling