Переглядів 8,430
Hello everyone, Alexander is with you, I am building a garage with a house, in this video I will tell you how I installed a two-post lift with my own hands- Let's go!
We started by installing the racks in the right places and marking the drilling points for mounting the lift to the floor, I was lucky and when drilling concrete I did not hit the rebar because I laid it myself and knew approximately where it was located.
Concrete was drilled with a 20mm drill to install anchors with a length of 250mm and a diameter of 20mm, the floor is a slab foundation that I poured myself has a thickness of 250 mm and is in tolerance for installing a double-column lift with a lifting capacity of 4 tons on it.
I took the anchor bolt with a margin of safety, a good manufacturer who advised me in the store where I bought the lift.
All anchors were installed, the nuts were slightly stretched so that the anchors were fixed in the concrete and the racks were lowered for further assembly.
The lift in the warehouse where I bought it was loaded into the car by a loader, but in order to unload it from the car I had to