That's quite a compliment! Glad you enjoyed it.

That's why I gave it a like lol

5:53

ukposts.info/have/v-deo/ipynqm-tam6A05s.html .

yes

so satisfying

i saw what you did there

Very wonderful 🌚🔪❤️

Найс

True, but I'd recommend more than just a light grooving. Friction is one thing at room temperature, but the engine could catastrophically seize from thermal expansion of the aluminum piston during operation. He should reduce the contact area by grooving most of the surface area to a shallow depth. One ring should remain near the top of the piston, and another ring should be as low as possible without interfering with the wrist pin, and without exiting the cylinder at BDC. The top ring will seal gasses, and the bottom ring will function as a skirt to keep the piston from rocking too much. If the bottom ring seals too effectively, it could prevent enough oil from getting up to the top ring. In that case the location of the bottom ring can be moved closer to the top of the piston and/or the OD of the bottom ring can be slightly reduced on the replacement piston. Of course the right way to do it would be to have separate rings that are free to compress into a deeper groove, but that's quite a bit more work.

Thanks!

Me too. Subb'ed

Who wouldn't like this? :0

Metoo!

You're nice guy

Amazing!!

@@mofarehalsubaie3335 thanks When do you from?

Bruh same

👍😎

Thank you!!

@@horvatdavid2625 what

Honestly I wasn't expecting an 80cc engine, but I was surprised at how small it is. It's still cool, but I also wished it was larger. Maybe in the future when he gains experience from this build, he may move on to a larger engine

@@horvatdavid2625 Lmao

These Sherline tools can't handle anything large. To be honest I doubt it could handle the size of the flame licker I built using full sized equipment. I use my Sherline with denford add ons for small runs and test runs or even a miniature run before making a bigger version of what I'm making.

Thanks!

@@MakerB Confira o meu canal

Thanks!!

ukposts.info/have/v-deo/h4eZoYOeoWaIkWg.html

Thanks!✌️

You had one job

ukposts.info/have/v-deo/hoZhiq2crKKTyIE.html