Thank you sir, wonderful work!

Thank you very much sir.. This is the first time I understand why I get the Error message sending AT Commands

Thanks, I found this very useful !

I have a doubt is codes for Hm-10 and Hc-05 are different? Because already have project on HC-05 and if I now just replace this Bluetooth module to Hm-10 is this previous code work properly or I need to alter? Last question Do i need power division in 3.3v for RX if I connect with Arduino Uno?

So informative sir 👍

Hi. Useful video. It would be nice to link the other parts in the description

Very useful video Sir..

Thank you sir.. This video is very helpful.. I want to know without level shifter this setup will work..

very helpful, thank you

Sir is stm32 nucleo f103rb dev board is advisable for stm32 beginners? any suggestions?

After connection is estabilihsed using coolterminal, how do we request for UUID, characteristic and notofications thorogh same hyper terminal? (We need to receive the periperal notifications in terminal)

Great video

Hi, how to set HM-10 so it can replace HC-05? We have Bluetooth classic MIT APP INV APP that works well with HC-05 but not with HM-10. So can HM-10 work as a HC-05 after setting it's parameters?

Beyond great 👍♥👍

Helps lots. thanks

Hi sir. Pls make a vidoe on how to use secondary UART on Raspberry Pi 4. I have gone through your video on enabling and swapping primary UART. But I need to use 2 UARTs simultaneously. Pls help

When will part2 come out?

Excellent!!!!!!

Supper demo

Heey. i tried to update my cc41 and it didnt come out of a wait screen. it was showing up on the scanners but now it doesn't show up but the led blinks. What do I do? I can't find you with any app

Can we make ble mesh using this?

Sir it is TTL output or serial output. Pls tell me

Good video

Sir, plz tell where you purchased original hm-10

Hi sir tnxs for this vedio Sir in this project shell we connect mobile bluetooth sir because our mobile is default master know is there any possibility sir

Part 2 ?

Hello, for me it works without resistance

Hi sir kind and upload videos for TOP2013 universal programmer

Range

thanks for this video, How can i remove the password?

there no need of resistors