PCBway is the one having their anniversary but you are the one giving us the gifts! Thank you for the platform for prototyping and fixes

Happy Friday!!! Great content as always, thanks for sharing.

Nicely done with the protoshields that you designed.

I ordered those boards as well, and mine have 3 mounting holes

Thanks for this video :) Do you happen to have a list of "free to use" pins that aren't actually free to use? Don't have such a module yet, looking for info about this first.

thank you for your tutorials and all your effort it helps a lot of us . just im using that device for indistruel usage and im trying to use TASMOTA as firmware but right now it not very reliable any recommendations ?

One Other Question I was just curious about, Did you setup the Proto Shield to have that Pinout for the I2C Bus so it would work with the NCD I2C Modules? I noticed the pinout was perfect for soldering their 4 wire Molex connector, thus making this a Master Device for their i2c Sensor series.

Hi, Nice tips and design, I just wonder if it isnt possible to rotate the board 45 degrees and have the extra pinouts on the back? So it uses more the slimline of the device itself.

7:30 maybe connect reset pin on device so it doea not power on until voltage stabilize? I don't know if it supports that... But nice hint 🙏

Thanks for sharing the PCB! Would this be compatible with the regular ESP32-PoE from Olimex (non-ISO version?)

Where do you get those colored male pins from?

Hello, I am really interested in this board. Do you think I can use the POE to power a camera? I need to send 7.5V and 2A to the camera. Any idea how I could do that? Thank you.

Do you have a video as a Code Walk to using your sketch? I barely know enough about Programming to make sense of the code, but I've never used OTA updates before. I'd like to implement that with an MQTT Client to change how to Pub and Sub Events on the board.

You should check out the wesp32. It is better in every way. More free pins, more power from the POE output (12v or 5v), mounting holes, etc.

Btw! New board revision "K" includes mounting holes!!!

This board, which I have just discovered, seem to be exactly what I need, provided that: 1. I can add a battery, and the ability to charge said battery, when powered via PoE. 2. The ability to control a single 240v relay. Presumably this is not an issue. 3. The ability to use it as an actual internet connected WAP. I don't see why this should not be possible, but it may not be. 4. the ability to connect a proper antenna, preferably more. I've seen versions of this board with a single antenna, but not tow or three. Lastly, and not really a necessity in regards to this specific board, but ideally, a readymade board, including relay. Also, POE is really not a necessity, in fact if would be a convenience to have it mains powered, though I suspect it will be less power efficient, when in deep sleep, not the ESP32 itself, but the whole package, of course, as opposed to battery power. I also think that the price is a bit... spicy, but it'll do, if nothing better is available. Any recommendations?

Hello, how do you deal with displaying text on this display board standard LiquidCrystal driver causes an error in displaying the text, it does not erase the previously entered text and garbage is left on the screen

You: There are problems and I know how to fix them. You: The documentation looks good but it's wrong. Also you: There's a problem with a "Free to Use pins" for PoE compared with the documentation but I'm absolutely not going to tell you what the problem pin is or how to fix it.