UART (Universal Asynchronous Receiver Transmitter)

UART (Universal Asynchronous Receiver Transmitter) - Basics

День тому

I have explained the basics of #UART communication in this video.
UART stands for Universal Asynchronous Receiver/Transmitter. It is used in #microcontrollers and FPGAs.
I have covered an explanation of the baud rate, UART frame structure, and parity bit.
Comment down your answers to the question.
LIKE and SHARE the video.
SUBSCRIBE to the channel!
UART in MSP430: • MSP430 UART - Tempera...
UART troubleshooting steps: • UART - Troubleshooting...
-------------------------------------------------------------------------------------------------------------------------
You can find me on:
🐦Twitter: / beebhatt
💼 LinkedIn: tinyurl.com/byp28c7y
Cheers!
#serialcommunication

КОМЕНТАРІ: 16

@BinaBhatt 2 роки тому

I have explained the basics of #UART communication in this video. UART stands for Universal Asynchronous Receiver/Transmitter. It is used in #microcontrollers and FPGAs. I have also covered an explanation of the baud rate, UART frame structure, and parity bit. Comment down your answers to the question. LIKE and SHARE the video. SUBSCRIBE to the channel! UART in MSP430: ukposts.info/have/v-deo/apdqo56vo35k1GQ.html UART troubleshooting steps: ukposts.info/have/v-deo/ql1_aWmdp5d7uKM.html

@dnyaneshvarsalve Рік тому

Liked the video, Would like to understand more on parity from your side

@DjPrEvo Рік тому

You are so magically clear! Thanks a lot for this videos on your channel Bina!

@BinaBhatt Рік тому

You're welcome!!!

@msbanda2123 Рік тому

Very useful video 👍

@shrikantnikam2426 Рік тому

thank you for video , its quality content , subscribed.

@MSR32 2 роки тому

Can u do vedio on I2S and DDR interface a

@k283 Рік тому

The receiver should sample the signal in its middle (not on the edge). This is because real life electronics aren't perfect, and there may be latency or voltage jumps here and there; so for example a transmitter's voltage level can go from LOW to HIGH, but if it lags by just a few microseconds after the designated time for leading edge arrives, the receiver will actually still see a LOW level signal, which is a mistake. Thus the sampling should be done in the middle.

@ulysses_grant 5 місяців тому

Thank you!

@sivapraveens9643 Рік тому

Very useful content

@BinaBhatt Рік тому

Glad it was helpful! Subscribe to the channel for similar content!

@kalpavrukshg8853 2 роки тому

According to me the signal should be sampled at the edge i.e when transition takes place according to design we can have positive or negative edge detection.