Today I answer any questions folks have, show the flash changes for RP2040, most other ports, show off the iMX RT dev boards from NXP and discuss the iMX RT flash changes. Visit the Adafruit shop online - www.adafruit.com
I’m sponsored by Adafruit to work on CircuitPython. Support them, and by extension me, by purchasing hardware from adafruit.com
Chat with me and lot of others on the Adafruit Discord at adafru.it/discord.
Deep Dive happens every week. Normally Fridays at 2pm Pacific but occasionally shifted to Thursday at 2pm. Typically goes for two hours or more. Questions are welcome.
Next week will be on Friday. The week after on Friday I’ll be speaking at the Open Hardware Summit in the morning and then streaming the 1 year anniversary in the afternoon at the normal time.
SMD boxes:
www.amazon.com/dp/B008GDSGTK/
www.amazon.com/dp/B078RFCQSG
0:00 Getting started and hellos
04:11 Housekeeping
09:42 digikey order
20:41 designing a pcb?
24:19 How to configure the UART receive interrupt in Circuitpython?
26:17 USB host is supported on the Teensy 4.1, plan to support in CP?
27:28 What is the intended purpose of the Seesaw?
30:11 What are/would be the major milestones to get a BT-only experience working on a CP device?
38:35 HCI
39:24 So would REPL be part of the initial BT/BLE workflow, or a later enhacement?
41:24 Can we do BT gateaway chinese wall with BT on the AirLift and BT on the NRF52840?
43:04 Switching platforms - iMX unboxing
53:51 Doesn't the Teensy have a proprietary part? Like the bootloader? And it is supported. Where other iMX board are "raw"? So what will be the difference for CP support?
1:19:35 check on flash PR
1:29:50 How to add a flash chip to nvm.toml
2:08:51 wrap-up
-----------------------------------------
LIVE CHAT IS HERE! adafru.it/discord
Adafruit on Instagram: / adafruit
Subscribe to Adafruit on UKposts: adafru.it/subscribe
New tutorials on the Adafruit Learning System: learn.adafruit.com/
-----------------------------------------