Many of you have seen the process of making this rotary valve engine with different intake and exhaust system and how I tried to start it.
If not, then let's watch the previous video first:
• I built a brand-new en...
After so many attempts to start this engine, I was ready to give up, but your incredible optimism and support inspired me to try again.
Thank you so much for your support, after reading all the comments I had no right to just give up.
Let's try to run it together.
I've highlighted some of your tips. So let's follow these tips one by one and see if the engine will work.
For those who don't know what the video is about.
I had an idea for a long time to create an engine without valves and springs.
Fuel and air enter the cylinder through a rotating shaft, which in turn is connected by a chain.
At the right moment, a channel for injecting the fuel mixture opens, and after detonation, the fuel is released through another channel.
As it turned out, there were a lot of variations of such engines, and many of them had already been used in the past.
As you have already noticed, I read almost all of your messages and am happy to share my ideas with you, and as far as possible, I listen to your opinion.
Share your opinion on this and leave comments.
With best regards
Meanwhile in the Garage
Fiido D3 Pro - Fiido D3 Pro Folding Electric Bike
Product link:
www.fiido.com/collections/d-s...
Code: D3pKol30, $30 OFF
#diyprojects
#prototypeengine
#buildingengine